Build a Tapered End Mill (page 1)

Revised 06/05/2008

Enter the Following Parameters for your Custom Tapered End Mill

Enter Shank Diameter: inches

Enter Small End (or Ball End) Diameter (>.0625 AND <1) and must be < the Shank Diameter: inches

Enter Taper per Side in degrees (ex: 5.13) must be < 90: degrees
Choose one End Type:

Ball End Diameter
Corner Radius
Square End

Copyright © 1999 [Triple-T Cutting Tools Inc.] All rights reserved.

Triple-T Cutting Tools, Inc.
135 Edgewood Avenue, West Berlin, NJ 08091
Phone: 856/768-0800 - Fax: 856/768-3773